Search results for "Gaseous diffusion"
showing 8 items of 8 documents
Selective chlorine determination by gas diffusion in a tandem flow assembly and spectrophotometric detection with o-dianisidine
2001
Abstract A fast, selective, sensitive and automated method for determination of free chlorine in industrial formulations and water samples is proposed. The automation of the flow assembly is based on the “tandem flow” approach, which uses a set of solenoid valves acting as independent switches. The operating cycle for obtaining a typical analytical transient signal can easily be programmed by means of friendly software running in the Windows environment. The manifold is provided with a gas diffusion unit which permits the removal of interfering species as well as concentrating the chlorine. The determination of chlorine is performed on the basis of the oxidation of o-dianisidine as the colo…
PET/PEN Blends of Industrial Interest as Barrier Materials. Part I. Many-Scale Molecular Modeling of PET/PEN Blends
2006
Mesoscale molecular simulations, based on parameters obtained through atomistic molecular dynamics and Monte Carlo calculations, have been used for modeling and predicting the behavior of PET/PEN blends. Different simulations have been performed in order to study and compare pure homopolymer blends with blends characterized by the presence of PET/PEN block copolymers acting as compatibilizer. A many-scale molecular modeling strategy was devised to evaluate PET/PEN blend characteristics, simulate phase segregation in pure PET/PEN blends, and demonstrate the improvement of miscibility due to the presence of the transesterification reaction products. The behavior of distribution densities and …
Highly protective alkalinization by ammonia vapor diffusion in viscosimetric DNA damage assessment.
1988
A method for the measurement of viscosities correlated to DNA alterations in alkaline homogenate suspensions is described. The alkaline pH shift to afford cell lysis, DNA unfolding, and denaturation is attained by gaseous ammonia diffusion, thus avoiding shear stress from mechanical mixing. At the same time a stabilizing density gradient is established. This solution is run through a plastic measuring tube that is wide enough to minimize the influence of uneven swelling of the lysing DNA-containing components. Flow times under a carefully controlled water head are registered, and their ratios to control solutions are evaluated. The relative viscosities show a strong and irreversible depende…
Determination of the oxygen transmissibility and permeability of hydrogel contact lenses
1999
To test the validity of the method of stacked hydrogel contact lenses to obtain the oxygen permeability and transmissibility coefficients of the lenses, the coefficients of one low hydration (38% water) and two high hydration (55 and 58% water) hydrogel contact lenses stacked one to five on an oxygen electrode were deter- mined. From the oxygen diffusion through the lenses, the current intensity in the stationary state was determined, and from this the "instrument" the oxygen transmis- sibility was obtained. The permeability coefficients of the lenses, corrected for edge effects, were obtained from the slope of the plot of the reciprocal of the transmissibility coefficients versus the lens …
Bromine speciation in volcanic plumes: new in situ derivatization LC-MS method for the determination of gaseous hydrogen bromide by gas diffusion den…
2020
The chemical characterization of volcanic gas emissions gives insights into the interior of volcanoes. Monitoring of BrO/SO2-ratios has recently been correlated with changes in the activity of a volcano. BrO and SO2 can both be measured autonomously and simultaneously with the same instruments from a safe distance, making their ratio potentially a strong monitoring tool. However, BrO is not a primary emitted volcanic volatile and there exist still uncertainties about the formation of BrO in volcanic plumes, mostly due to the lack of analytical approaches for the accurate speciation of certain key compounds. This study describes a new method for the determination of the BrO precursor, the ga…
In Situ Regeneration of Copper-Coated Gas Diffusion Electrodes for Electroreduction of CO2 to Ethylene
2021
This research was funded by the European Union’s Horizon 2020 research and innovation program under grant agreement No 768789 as well as by the Polish National Centre of Science under grant no 2017/26/D/ST8/00508. The Institute of Solid State Physics, University of Latvia, as a center of excellence, has received funding from the European Union’s Horizon 2020 Framework Programme H2020-WIDESPREAD-01-2016-2017-TeamingPhase2 under grant agreement no. 739508, project CAMART2.
Solubility and diffusion of nitrogen in maltodextrin/protein tablets.
2002
The gas transport properties of compacted tablets consisting of an amorphous mixture of maltodextrin and sodium caseinate were studied by dissolving nitrogen gas in the tablets and then determining the gas release over time as a function of temperature and water activity. Gas was dissolved in the tablet matrix by heating the tablets under pressure, generally to temperatures above the glass transition temperature of the matrix, holding them at these conditions for a specified time and then rapidly cooling them while maintaining the external pressure. The solubility of nitrogen was found to be largely determined by the free volume of the matrix, which in turn can be influenced to some degree …
Characterization process to measure the electrical contact resistance of Gas Diffusion Layers under mechanical static compressive loads
2016
AEM2016. International conference on Advanced Energy Materials, University of Surrey, Guildford, ROYAUME-UNI, 12-/09/2016 - 14/09/2016; Recent research has identified the mechanical properties of the fuel cell internal components (in particular, the Gas Diffusion Layers - GDLs) as key-parameters to obtain high final performances of the generator. The mechanical compression modulus of these components, the stability of their mechanical properties with respect to temperature and humidity, and their ability to interact with water have an impact on the electrical contact resistances in the stack and, by consequence, on the overall performance of the electric generator. Reducing the losses by co…